Removing
Warning. When removing and installing the shift lever and the shift rod, be careful not to hit the electronic control unit of the additional passive restraint system (SRS-ECU).
- Remove the center console.
- Turn out an adjusting bolt of draft of a gear change (pic. 12.9).
Pic. 12.9. F5MR1 Gearbox Shift Mechanism: 1 - adjusting bolt of gearshift rod, 24 Nm; 2-tip of gearshift rod assy (from the gear lever side); 3 - a tip of draft of a gear change assy (from the gearbox side); 4 - gearshift rod; 5 - ring gasket; 6 - gear shift rod bushing; 7 - sleeve; 8 - gearshift lever assembly
- Turn away a nut and take a bolt of fastening of draft of a gear change from the side of the gear lever.
- On the wire, hang the gear shift rod assembly from below to the vehicle transmission elements.
- Turn away a nut and take a bolt of fastening of draft of a gear change from outside a transmission. Remove the o-rings, shift rod bushings and sleeve.
- If necessary, remove the bolts and remove the shift lever assembly.
Installation
- Installation is carried out in the reverse order of removal, taking into account the following.
- Check the operation of the reverse gear lock mechanism.
- Check the operation of the gear lever.