Pic. 5.9. Engine oil pan: 1 – the pallet of a crankcase of the engine; 2 - drain plug, 25 Nm; 3 - sealing ring; 4 - bolt, 13 Nm
Removing
1. Disconnect a wire from the negative plug of the storage battery.
2. Drain the engine oil from the engine.
3. Remove the pointer (oil dipstick) engine oil level.
4. After turning out of bolts of fastening of the pallet of a crankcase of the engine separate a pallet of a crankcase of the engine from the block of cylinders with a screw-driver.
Attention! Be careful not to deform the engine sump flange.
5. Turn away a stopper of a drain aperture and remove a sealing ring.
Installation
Installation is carried out in the reverse order of removal, taking into account the following.
1. Clean the engine sump with kerosene or a suitable solvent and remove dirt from the outside and deposits from the inside of the engine sump. Clean the mating surfaces of the engine oil pan and engine block from the remnants of the old gasket. Check that surfaces are clean and dry.
2. Apply a 4 mm bead of 970389 sealant to the engine oil pan flange.
3. Fix the oil pan with bolts, tightening them with a torque of 13 Nm.
4. Fill the engine with engine oil.
5. Install the engine oil level gauge.