The film of tar and dirt that forms on the brushes reduces their effectiveness, so the brushes should be washed from time to time with clean water and soap.
Replacing the rubber pad of the wiper blade
1. Raise the wiper arm above the glass.
2. Pull the wiper blade cover, its limiter
Pic. 2.15. Removing the rubber pad of the wiper blade: A - limiter; B - hook; C - base plate
A (pic. 2.15) must disengage from the hook IN. Moving the overlay further, remove it.
Attention! Do not let the wiper arm fall on the windshield, which could damage the glass.
3. Install the base plates WITH in a new rubber wiper blade.
4. Establish an overlay of a brush of a screen wiper in a brush since the side of an overlay, opposite from the limiter. Make sure the hook IN (pic. 2.16) correctly installed in the grooves of the lining.
Pic. 2.16. Overlay installation (A) wiper blades in the brush, hook (IN) must be correctly installed in the grooves of the lining
Attention! If the new wiper pad kit does not include new wiper blades, use the wiper blades from the old wiper.
5. Push the wiper blade until the hook IN (see fig. 2.15) will not enter into reliable engagement with the limiter A.