General information about the rear suspension Pic. 16.1. Rear suspension: A - cars with SOHC engines; B - cars with DOHC engines Rear suspension - multi-link with two trailing arms (pic. 16.1). Rear strut shock...
Rear wheel hub — removal, inspection and installation Removing To remove the rear wheel hub, perform the following steps in sequence. Pic. 16.3. Rear wheel hub design: A - cars with rear disc brakes; B - cars with rear drum...
Checking and adjusting the rear wheel alignment 1. Install the car on a flat horizontal platform and measure the angles of the rear wheels. 2. Before measurement, the elements and parts of the rear suspension and...
Corrective, upper and lower rear suspension arms Removing To remove the rear suspension arms, perform the following steps in sequence. 1. Raise the rear of the vehicle and secure it to stands. Remove the relevant wheel...
Replacing the bushing of the lower arm Pic. 16.9. Pressing out the lower arm bushing: 1 - special tool МВ991447; 2 – bracket MB991449; 3 – special tool МВ991448; 4 - special tool МВ991449 Pressing out and...
Rear pillar — removal, inspection and installation Note. familiar (*) parts are marked that must be pre-tightened, and then carry out the final tightening by lowering the unloaded car onto the wheels. Removing To remove...
C-pillar repair Attention! A spring compressor must be used to disassemble the rear strut. Disassembly To disassemble the rear rack, perform the following operations. Pic. 16.17. Rear...
Anti-roll bar — removal, inspection and installation Removing To remove the anti-roll bar, perform the following steps in sequence. Pic. 16.21. Roll Stabilizer: a - places for applying lubrication; 1 - bolt (34 Nm); 2 – an...