Car heater and air conditioner Mitsubishi Pajero 1 and 2

Heater fan motor — removal and installation
Heater blower unit (1983-89) 1. Bottom air duct cover; 2. A box for small things; 3. Cable dividing damper; 4. Air duct; 5. Block blower; 6. Resistor; 7. Hose; 8....

Heater radiator — removal and installation
Front panel (1987-91) 1. Air duct bottom cover B; 2. Lower air duct cover C; 3. An arm of a cable of a drive of the lock of a cowl; 4, 5. Side ventilation windows; 6. A...

Heater control panel and blower switch
Heater control panel (1983-91) 1. Drawer locks for small items; 2. Cable drive damper junction box; 3. Handles; 4. Plug; 5. Central section; 6. connector; 7. Lower...

Air conditioning compressor — removal and installation
Compressor mounting on G63 engines (1), G55 (2), D55 (3) Air conditioning compressor (6-cylinder engines) 1. Belt; 2. Hose fittings; 3. O-rings; 4. Compressor; 5....

Air conditioner condenser — removal and installation
Attention! Disassemble the capacitor connections without exerting much force, tighten them without exceeding the specified torque. When assembling, replace the O-rings....

Auxiliary condenser and air conditioning fan
2-stage air conditioning and auxiliary condenser and fan vehicles 1983-91 1. Bolt; 2. Receiver / water separator; 3. connector; 4. Fan bolt; 5. Fan; 6. Bolt; 7....

Air conditioner evaporator — removal and installation
Evaporator and heater core cover (1983-91) 1. Line with liquid refrigerant; 2. Suction line; 3. Nut; 4. A box for small things; 5. connector; 6. Transition section; 7....

Rear air conditioner evaporator — removal and installation
Rear evaporator parts (1983-91) 1. Line with liquid refrigerant; 2. Fitting; 3. Ring; 4. Air duct; 5. connector; 6. Evaporator Rear Air Conditioner Duct System 1....

Air conditioner switch — removal and installation
Air conditioner switch (1983-91) 1. Air duct; 2. Clips; 3. Handles; 4. Plugs; 5. Facing; 6. connector; 7. Switch On cars 1992-98, the air conditioning switch is mounted...

Air conditioning control unit — removal and installation
Air conditioner control unit 1. Clips; 2. Control box Removal and installation 1. Remove the drawer for small items by pressing the latches. 2. The block is mounted...

Air conditioning line — general information
Bends of hoses and tubes of the line at small angles are not allowed. The bend radius must be at least 10 times the hose diameter. The hoses must run at least 80 mm from...

O-rings for refrigerant pipes
Air conditioning line seals and tightening torques N - the seal must be replaced when disassembling the connection When replacing the seals of the detachable connections...