Rear cover
1. Sealant internal; 2. Outer seal; 3. Clamping bar; 4. Buffer; 5. Spare wheel holder; 6. connector; 7. Closing limiter; 8. Hinge bolt; 9. Lid; 10. Cotter pin; 11, 12. Loops; 13. Lid opening limiter; 14. Retainer; 15. Gasket; 16. Buffer cover; 17. Reciprocal buffer socket; 18. Bracket
Removal and installation
Attention! The work is done in pairs.
1. Remove the spare wheel and wheel holder.
2. Remove facing of an aperture of a back cover.
3. Remove the rear belt tensioner cover (if belts are provided).
4. Remove the speaker (on 4-door bodies).
5. Remove the rear bottom panel.
6. Remove facing of a back rack.
7. Unpin and remove the axle of the cover stopper.
8. Disconnect the washer hose.
9. Disconnect the wires from the rear cover.
10. Outline the hinges, unscrew the hinge bolts on the cover and remove the cover.
11. Installation is carried out in the reverse order.
12. Tighten all fasteners to the correct torque.