Operations before removal and after installation.
Removing and installing side cover and bottom cover.
Removal and installation of a ware box of the floor console.
Checking the operation of the selector lever (only after installation).
Attention! Be careful not to subject the SRS electronic control unit to any impact when removing and installing the selector cable and selector lever assembly.
Check of chains of the gauge-switch switch assy
Checking the mechanisms for blocking the switching of automatic transmission modes
Basic Installation Operations (nut installation)
Set the automatic transmission selector lever to the position «N».
Loosen the adjusting nut; Gently pull the selector lever cable in the direction shown in the illustration, and tighten the nut.
Full throttle sensor test
