Battery, alternator and car starter Mitsubishi Outlander 1

Checking the condition of the battery and its terminals
Check the condition of the battery terminals. Make sure they are securely fastened. Note. Do not remove grease from the battery terminals and wire fasteners.

General information about the power supply system
The power supply system is used to recharge the battery in the car. Principle of operation When the excitation coil rotates, through which an electric current is passed,...

Checking the voltage drop on the wire of the generator with the battery
This test is carried out to determine the condition of the connecting wire between the terminal «IN» alternator and positive battery terminal (including fusible link)....

Checking the output current of the generator
This test is carried out to determine the output current of the generator. Check the following before performing this test. Alternator mounts Rechargeable battery....

Checking the regulated voltage
This test is designed to test the voltage regulator. Check the following before performing this test. Generator mounts. Make sure the battery in the vehicle is fully...

Removing voltage waveforms using an oscilloscope
Connect an oscilloscope probe to measure specific signals (special patterns pick-up) to the conclusion «IN» generator. Measurement method The condition under which the...

Removal and installation of the generator
Operations to be carried out before removing the generator Remove the protective cover. Remove a cross beam of racks of a forward suspension bracket. Remove the drive...

General information about the engine start system
When the ignition key is turned to position «START» (starter) current from the battery enters the retracting and holding windings of the traction relay. The armature of...

Removal, check and installation of a starter
Removing The starter is removed and pulled up. Operations to be performed before removing and after installing the starter Remove (install) air filter. Remove (install)...