Home Colt Lancer Galant L200 Outlander Pajero Others

Outlander 1 (2003-2008)

Removal and installation of the camshaft position sensor

0

Removing

Disconnect the camshaft position sensor connector 1.

Remove the camshaft position sensor 2.

Remove O-ring 3.

Installation

The components are installed in the reverse order of removal.

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share with friends:

◀ Previous

Outlander 1: Ignition system

Next ▶

Removal and installation of ignition coils
Checking the ignition coil relay
Examples of high voltage waveforms of a faulty ignition system
Removing high voltage waveforms using an oscilloscope
Maintenance operations carried out directly on the vehicle
General information about the ignition system

Removal and installation of the knock sensor
Removal and installation of the ignition switch
Checking the speedometer
Checking the tachometer
Checking the fuel level sensor

Similar materials for other Mitsubishi models

➤ Camshaft — removal and installation (SOHC, 8 and 12 valves) Mitsubishi Colt 4 and 5 (1991-2003)
➤ Removal and installation of a camshaft of a gasoline engine Mitsubishi Lancer 3 and 5 (1984-1992)
➤ Removal and installation of the fuel pump / fuel flow sensor Mitsubishi Galant 6 and 7 (1987-1998)
➤ Removal and installation of the steering wheel position sensor Mitsubishi L200 4 (2005-2014, diesel)
➤ Overload sensor — removal and installation Mitsubishi Pajero 1 and 2 (1982-1999)
➤ Camshaft position sensor Mitsubishi Space Star (1998-2005)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet