Drive shafts and car gearbox Mitsubishi Lancer 9

Transfer box assy
Removing the transfer case assembly. 1 - guide, 2 - boot protection, 3 - rear support bolt, 4 - transfer case assembly, 5 - o-rings. Note: the nut fastening the variator...

Cardan shaft
Removing Note: − Removal of parts is carried out in the order of numbers indicated in the figure "Removing the cardan shaft". − When removing parts, pay attention to the...

Checking the axial clearance of the front wheel hub
1. Remove the brake caliper assembly and hang it with a wire. 2. Remove the brake disc from the front wheel hub. 3. Set the dial indicator as shown in the figure and...

Front wheel hub
Removing Note: - Removal of parts is carried out in the order of numbers indicated in the figure "Removing the front wheel hub". - Pay attention to the following...

Drive shafts
Removing Note: - Parts are removed in the order of the numbers indicated in the corresponding figure "Removal and installation of a forward power shaft". - (4WD Models)...

Drive Shaft Disassembly and Assembly (2WD Models)
Disassembly Note: disassembly is carried out in the order of the numbers indicated in the figure "Disassembly and assembly of the drive shaft". When removing parts, pay...

Preliminary checks
Rear wheel hub (2WD) 1. Measure the axial clearance of the hub A) (Models with drum brakes) Remove the cap and brake drum from the rear wheel hub. b) (Models with disc...

Rear wheel hub (2WD)
Removing Note: - Before starting to remove parts: A) Check the axial clearance of the rear wheel bearing, b) Check the torque of the rear wheel bearing. - Removal is...

Rear gear
Removing Before you start removing parts, do the following: A) Unscrew the drain plug and drain the oil from the gearbox housing. b) Remove the elements of the exhaust...