Electrical equipment and appliances Mitsubishi Lancer 9

Egnition lock
Removal and installation Attention: before removing the airbag module and SRS coiled wire, read the safety precautions given in the appropriate section of the chapter "...

Checking meters and indicators on a car
Checking the speedometer Note: A possible cause of speedometer malfunction is a malfunction of the vehicle speed sensor, an open in the wiring harness, or a malfunction...

Instrument cluster
Removal and installation - Parts are removed in the order of the numbers shown in the figure "Removing the instrument cluster". Removing the instrument cluster. 1 -...

Outdoor Lighting
Note: Lamp replacement is described in chapter " Manual ". Headlight adjustment Preparing to adjust the headlights 1. Check the headlight assemblies for faults,...

Sound signal
Checking the horn relay 1. Check for continuity between terminals "2" - "3" relay when no power is applied. 2. Supply power (battery voltage) to conclusions "2" (-) And...

Car cigarette lighter
Examination 1. Remove the heating element from the cigarette lighter socket and check the contact condition of the heating element. Remove tobacco residue or other...

Connector for connecting additional equipment
Checking the relay connector for connecting additional equipment 1. Check for continuity between terminals "1" - "4" relay when no power is applied. 2. Supply power...

Steering column combination switch
Removal and installation - Parts are removed in the order of the numbers shown in the figure "Removing the stalk combination switch ". Removing the stalk combination...

Car clock
Removal and installation - Parts are removed in the order of the numbers shown in the figure "Removing the watch". Removing the watch. 1 - heater and air conditioning...

Car audio system
Troubleshooting for Radio Interference Note: To reduce the effect of interference, tune into a station with a strong radio signal or adjust the sound quality (turn down...

Mitsubishi Multi Communication System (MMCS)
General information 1. The MMCS integrates the navigation system, audio system, air conditioning system, trip computer, TV tuner, self-diagnosis system, help system into...

Outdoor temperature sensor
Removal and installation Procedures for removing, installing and checking the outdoor temperature sensor are given in chapter " Heating, air conditioning and ventilation...

Rear window heater
Checking the heating element Caution: Wrap thin foil around the tip of the voltmeter probe to prevent damage to the heating element conductor. Use your finger to press...

Mitsubishi Multiplex System (SWS)
General information 1. The SWS system allows communication between the electrical control module, the ETACS control module, the stalk combination switch controller, the...

Location of connectors in the engine compartment
Note: in the figures, the thick dashed lines show the wire harness, which is enclosed in special insulation; symbol "" Standard wiring harness attachment points are...