Doors, locks and windows of the car Mitsubishi Lancer 9

Body checks and adjustments
Hood adjustment 1. Loosen the hood mounting bolts and, moving the hood, adjust its position so that the gap on all sides is the same. 2. Adjust the hood height by...

Additional anti-roll bar (wagon modifications from 05.2001)
Removal and installation − When removing and installing the additional anti-roll bar, refer to the figure "Removing the additional stabilizer bar". Removing the...

Car bonnet
Removal and installation - Parts are removed in the order of the numbers shown in the figure "Removing the hood". Removing the hood. 1 - rubber hood support, 2 - hood...

Car fender
Removal and installation − Remove the front bumper before starting to remove parts. - Parts are removed in the order of the numbers shown in the figure "Wing removal". −...

Fuel tank filler cap
Removal and installation − Before starting to remove the cable parts, carry out the following operations: A) Remove the rear seat assembly. b) Remove the front side door...

Windshield
Removing − Before starting to remove parts, carry out the following operations: A) Remove the windshield wipers. b) Remove the front pillar trim V) Remove the ceiling...

Luggage compartment fixed side window (station wagon)
Removal and installation − Before starting to remove parts, carry out the following operations: A) Remove the luggage compartment side trim. b) Remove the ceiling trim....

Rear window (sedan)
Removal and installation − Before starting to remove parts, carry out the following operations: A) Remove the rear pillar trim. b) Remove the rear window wiper motor. V)...

Rear door glass (station wagon)
Removal and installation − Before starting to remove parts, carry out the following operations: A) Remove the upper brake light assembly. b) Remove the rear door trim. -...

Side door assy
Removal and installation - Parts are removed in the order of the numbers shown in the figure "Removing the side door". Removing the side door 1 - buffer, 2 - side door...

Side door trim and waterproof film
Removal and installation - Parts are removed in the order of the numbers shown in the figure "Removing the side door trim and waterproof film". Removing the side door...

Side door glass and power window
Removing − Remove the side door trim and waterproof film before beginning to remove parts. − Removal of parts is carried out in the order of numbers indicated in the...

Side door lock and handle
Removal and installation − Before starting to remove parts, carry out the following operations: A) Remove the side door trim. b) Remove the waterproof film of the side...

Guide groove and side door seal
Removal and installation − Before starting to remove parts, carry out the following operations: A) Remove the side door sill trim. b) Remove the front side trim. V)...

Trunk lid (sedan)
Removal and installation − Remove the boot sill trim before beginning to remove parts. - Parts are removed in the order of the numbers shown in the figure "Removing the...

Tailgate (station wagon)
Removal and installation − Before starting to remove parts, carry out the following operations: A) Remove the rear spoiler assembly. b) Remove the rear window wiper...

Rear door trim and waterproof film (wagon)
Removal and installation - Parts are removed in the order of the numbers shown in the figure "Removing the rear door trim and waterproof film". Removing the rear door...

Rear door lock and handle (station wagon)
Removal and installation − Before starting to remove parts, perform the following operations; A) Remove the rear door trim. b) Remove the waterproof film. - Parts are...

Sunroof
Removal and installation - Parts are removed in the order of the numbers shown in the figure "Removing the sunroof". Removing sunroof. 1 - glass hatch cover assembly; 2...

Central locking remote control system
Registering a transmitter key Note: data about registered transmitter keys is stored in non-volatile memory (EEPROM), in the ETACS electronic control unit. When...