Car clutch repair Mitsubishi Lancer 3 and 5

Clutch — device
The clutch consists of a drive plate, a driven plate and a mechanical or hydraulic control system. Drive and driven discs are located at the engine flywheel There is a...

Removal and installation / clutch check
Remove the gearbox see point 12.1 . Mark the position of the drive disk on the engine flywheel with a felt-tip pen or a marker. Stop the engine flywheel by inserting a...

Removal and installation of release bearing
The figure shows a 1.3/1.5 liter engine. 1 - Retaining spring 2 - Release bearing 3 - Spring pin 4 - release lever 5 - Return spring 6 - squeezing fork 7 - Gasket "A" 8...

Checking/Adjusting the Clutch Pedal Free Play
Clutch pedal height and free play should be checked if there is difficulty disengaging and engaging the clutch, and after removing the clutch master cylinder. Mechanical...

Removal and installation of the clutch cable
Removing Attention: Note the installation position of the clutch cable in the engine compartment and, during subsequent installation, route the cable in the same way....

Hydraulic clutch — device
1 - cotter pin, 2 - gasket washer, 3 - clamp, 4 - fork pin, 5 - clutch hydraulic tube, 6 - clutch hydraulic tube, 7 - hose clamp, 8 - clutch hose, 9 - hose clamp, 10 -...

Removal of air from the hydraulic clutch
It is necessary to bleed air from the clutch hydraulic actuator when, after pressing, the pedal does not return or returns with a delay, the gears are hard to engage, or...