Interior (internal elements) of the car Mitsubishi Lancer 3 and 5

Removal and installation of a covering of a ceiling
Describes removal and installation on COLT release from 9.88 On other models, the operations are similar. Removing Fold trim up and remove upper seat belt guides -16-....

Removal and installation of the middle console (cars of release up to 8.88)
1 - Drawer 2 - Decorative trim for the radio 3 - Facing of a manual brake 4 - Ashtray 5 - Miniature version of the console 6 - Console trim 7 - Large version of the...

Removal and installation of the center console (cars from 9.88)
1 - ECON switch or coin compartment 2 - Console drawer 3 - Switch or plug 4 - Rear of the console 5 - Gear shift knob 6 - Seat heating switch panel 7 - Seat heating...

Removal and installation of the dashboard / dashboard lining (cars of production up to 8.88)
Removing Disconnect the earth cable from the battery. Attention: This erases data in the electronic memory, such as the engine fault memory or the radio code. Disconnect...

Removal and installation of the dashboard / dashboard lining (vehicles from 9.88)
Removing Disconnect the earth cable from the battery. Attention: This erases data in the electronic memory, such as the engine fault memory or the radio code. Disconnect...

Removal and installation of an external mirror
Removing If present, remove the cross-head screw on the inner triangular trim. Remove triangular cover. Turn out 3 (on older models 2) screws and remove the outside...

Removal and installation of front seats
The seat is mounted on two guide rails, along which it can also move. Removing Vehicles from 9.88: Tilt upwards and remove covers for securing bolts. Vehicles up to...

Removal and installation of the rear seat
Removing the LANCER Pull forward both levers located at the front edge of the rear seat bench while raising the seat. On release models up to 8.88, instead of levers,...