Hatch opening
Sunroof opens automatically when the switch is pressed (3). To insert the sunroof, push the switch towards (3) or (2).
Note. The sunroof automatically stops short of reaching the fully open position. To open the sunroof fully, press the switch again.
Closing the hatch
The sunroof closes when the switch is pressed (2).
Hatch lift
When pressing the switch (3) the rear edge of the sunroof rises, providing interior ventilation.
Lowering the hatch
The rear edge of the sunroof lowers when the switch is pressed (2).
Safety mechanism
If a hand or head gets under the closing hatch, the hatch will automatically open.
However, before opening or closing the hatch, make sure that no one sticks their hand or head into it.
After the safety mechanism has been activated, the sunroof can be closed after a few seconds.
If the safety mechanism operates at least 5 times in a row or the switch (1) is held pressed for at least 10 seconds and the sunroof is in the fully raised position, it will not be possible to close the sunroof in normal mode. In this case, you must perform the following steps.
1. Repeatedly press the switch (1) until the sunroof is fully raised.
2. After the sunroof is fully open, press the switch again (1) and hold it for at least 3 seconds.
3. Pressing switch (3) fully open the sunroof, and then press the switch (2) and close sunroof completely.
4. After completing the above steps, you can close and open the sunroof in the normal mode.
Note. If, during movement, the sunroof is subjected to impacts or physical stresses similar to those that occur when a hand or head gets under it, the safety mechanism may operate.
When opening or closing the sunroof, try not to stop it at the end of the travel. If this still happens, repeat the above process starting from step 1.
The mechanism is also disabled at the end of the closing stroke, allowing the sunroof to close completely. At this point, you should be especially careful to ensure that your fingers do not fall into the gap.