Replacement
2. Remove the battery and air filter.
3. Move the selector lever to neutral.
7.4 Rotate the blocking switch so that its flange is aligned with the shorter of the two levers (A), then tighten the bolts
1. Lever; 2. Bolts; 3. Switch flange; 4. Unscrew the nut and disconnect the lever from the axle on the gearbox (7.4); 5. Disconnect the switch connector; 6. Turn off two fixing bolts and remove the switch; 7. Installation is carried out in the reverse order of removal
Adjustment
8. Rotate the switch so that the shorter of the two levers is aligned with the flange on the switch body, then tighten the bolts to the correct torque (7.4).
9. Check up operation of the mechanism of the selector and adjust the switch again if it is necessary.