Car automatic transmission Mitsubishi Colt 2 and 3

Specifications of automatic transmission
Gap between adjusting sleeve and gear selector lever Galant 15.2-15.9mm All other models 1986 and earlier 17.2-17.9mm Since 1987 15.2-15.9mm Throttle cable gap 1+0.5mm...

General description of the automatic transmission
The vehicles covered in this manual are equipped with a four- or five-speed manual transmission or a three- or four-speed automatic transmission. Due to the complexity...

Troubleshooting Automatic Transmission — General Description
Preliminary checks 1. Drive the vehicle to warm up the transmission to normal operating temperature. 2. Check the automatic transmission fluid level. 3. Check the engine...

Replacement of oil seals
1. For replacement of an epiploon of a semiaxle lift the car and establish it on support. 2. Remove half shafts. 3.3 Insert the tip of a large screwdriver (arrow) behind...

Transmission mountings — check and replace
4.1 Try to shake the gearbox mount with a large screwdriver 1. Insert a large screwdriver or crowbar between the mount and gearbox bracket and try to wiggle the mount...

Gear selector lever cable — removal, installation and adjustment
Removing 1. Disconnect the negative battery cable 5.2 The selector cable is attached to the lever on the gearbox with pins and washers and to the bracket with a clamp or...

Throttle cable (three-speed) — check and adjust
1. This cable controls shift speed, shift timing, and throttle sensitivity. Therefore, its correct adjustment is very important. 2. Start and warm up the engine. 6.3...

Interlock switch — check, replace and adjust
1 Try starting the engine in different selector lever positions - the starter should only engage when the selector lever is in neutral or park Replacement 2. Remove the...

Automatic transmission — removal and installation
Removing 1. Disconnect the wires and remove the battery and shelf. Remove the air filter. 2. Raise the vehicle and place it on stands. 3. Drain the automatic...