Car engine cooling system Mitsubishi Colt 2 and 3

Specifications of the cooling system
Are common Thermostat (opening temperature) 1993 Galant SOHC 16 valve engine 82°С All others 88°С Cooling capacity See Section 1 Cooling capacity Torques, Ft-lbs...

General information about the cooling and heating system
Engine cooling system All models have a closed cooling system, which includes a vane water pump, a wax thermostat, a cooling fan, an expansion tank and a radiator. A...

Antifreeze — general information
Attention! Antifreeze is highly toxic. If antifreeze comes into contact with skin or paint-covered areas of the car, it must be washed off immediately with water. The...

Thermostat — check and replacement
Attention! Do not remove the radiator cap, drain the coolant, or replace the thermostat while the engine is hot. Examination 1. Check the coolant level, tension belts...

Radiator — removal and installation
Attention! Wait until the engine has cooled down. Removing 1. Disconnect the negative battery terminal wire. 2. Drain the coolant. 3. Detach the clamps from the hoses,...

Engine cooling fan — checking and replacing elements
1. Engine cooling fan controlled by temperature switch (switch), located at the bottom of the radiator. 2. Check the fuses first. 3. To test the fan motor, disconnect...

Coolant temperature sensor — check and replace
Attention! Do not disconnect the sensor until the engine has cooled down. Examination 1. If the coolant temperature sensor is not working, check the fuses first. 2. If...

Expansion tank of the cooling system — removal and installation
1. Remove the expansion tank cap, and disconnect the water hose. 7.2 Loosen the plug and hose, unscrew the bolt (indicated by an arrow), then remove the expansion tank....

Water pump — check
1. Failure of the water pump causes overheating, which can cause serious damage to the engine. 2. There are three ways to check the water pump without removing it from...

Water pump — replacement and installation
Attention! Do not start this procedure until the engine has cooled down. Replacement 1. Disconnect the negative battery terminal wire. 2. Drain the coolant. 9.3 First...